2 Channel Receiver 12v Wireless Light Switch System Relay

2 Channel Receiver 12v Wireless Light Switch System Relay

Universal Wireless Remote Control 433MHz DC6V 12V 24V 2CH RF Relay and Transmitter Garage/Gate/Motor/Light/Home Appliance
Universal Wireless Remote Control 433MHz DC6V 12V 24V 2CH RF Relay and Transmitter Garage/Gate/Motor/Light/Home Appliance
The products can be used in homes, farms, factories, offices, laboratories, supermarkets, etc. Remote Control Garage Door \ Electric Door \ Home Door \ Shutter Door \ Expansion Door \ Gate Door \ Road Door
Remote Control Electric Curtain \ Water Pump \ Fan \ Lamp \ LED Light \ Bulb \ Ventilation Device \ Signal Transmission
Remote Control Motor Positive and Negative Rotation \ Motor Switch \ DIY
Relay Receiver Board Parameter
Working Voltage: DC 6V~30V
Input/Output: 1~250V
Quiescent Current: <5MA
Max Current: 10A
Max Load: 300W
RF Frequency: 433MHz
Working Temperature: -30~+80 Degree
Receiving Sensitivity: >97dbm
Storage Remote Control Quantity: 25pcs
Support Encoding: 1527 Leaning Code/2262 Fixed Code
RF Working Mode: ASK Superheterodyne Wireless Receiving
Receiving Range: Open Space Is Greater Than 50 Meters
Mode Remote Operation Mode: Momentary Mode/Toggle Mode/Latched Mode
Working Modes
You can set up 3 modes: Momentary Mode, Toggle Mode and Latched Mode.
Momentary Mode:
Press and hold button A, this relay will work; release button A, this relay will stop.
Toggle Mode:
Press button A, the relay will work; press button A again, this relay will stop.
Latched Mode:
Press button A, the relay will work; press button B again, this relay will stop, the second relay will work.
How to Set Up
Momentary Mode:
Press the learning button once, press A button once, succeed.
Toggle Mode:
Press the learning button twice, press button A once, succeed.
Locked Mode:
Press the learning button 3 times, press button A once, press button B once. Success.
Clean Data:
Press the learning button 8 times, the data will be cleaned. Not all remote controls can control this receiver.
If you want to change the mode, you need to clean the data first.